One-Touch Sequential System Control

  • Tested, complete package — low labor — mount next to circuit breaker panel to control AC power “hot” lines
  • Time proven, reliable, G-E RR7P3 latching relays snap in and have low voltage plug-in connectors
  • Low power consumption — no continuous relay coil current — runs cool for long life
  • Diagnostic LEDs and internal ON -OFF test switches speed installation for testing and troubleshooting
  • Cabinet and all components connected to high voltage are ULlisted — Electrician friendly
  • 4, 8 or 10 circuits — 120, 240 or 277 volt models available
  • Daisy-chains for unlimited circuitcount
  • Sequential turn on of electrical circuits, reverse sequence off, standard
  • Selectable delay step-rate setting standard
  • Simple set-up, no on-site commissioning required
  • Automatic load shedding for emergency shut-down standard
  • Brownout (under-voltage) shut-down for processor protection standard
  • Contact closure inputs for one-touch system control standard
  • Contact closure outputs optional on all panels
 ETL_Safety

The NEW IMPROVED PDS-10 board!

We’ve recently updated the PDS-10 board to include the same functionality as the MS-12.  Now you can choose step speed and program in two delay settings.

Move your mouse over the red dots Red-Dot.gif to see all of the great features.

You must install Adobe Flash to view this content.

G-E RR7 and RR9 Relay ratings

Power Contacts: Latching

  • 20A Tungsten, 125Vac 1/2HP motor at 110-125Vac
  • 30A Ballast, 277Vac 1 1/2 HP motor at 277Vac
  • 30A Resistive, 277VAC
  • 20A Ballast, 347VAC 1 1/2 HP motor at 220-277VAC
  • 20A Resistive, 347Vac

FOR COPPER WIRE ONLY

This product is NEC 110 Compliant when used in accordance withthe following: Suitable For Use On A Circuit Capable Of Delivering Not More Than 10 kA Sym. Amps., 277 Volts Maximum.UL Listed 508G Industrial Control Equipment — CSA certified

Low voltage characteristics — RR7P3 P3 suffix denotes a 3 pin, .156″ AMP or Molex connector attached.

RR9P has a five pin connector.  Actuating coils: 21-30 Vac (class 2) Momentary. OFF (1-black),ON (2-red), Common (3-Blue) 55-60 Ohms DCR, each coil.

Click to view.

Lyntec Seqencing Power Control Panel

Lyntec Seqencing Power Control Panel

Animation of a “one-touch” power sequencing system. LynTec allows you to control your complete audio video and lighting system with a simple touch of a button. Your system will power up properly, in the order specified, with the delays required, the right way every time.

PDS-10 Demo

PDS-10 Demo

LynTec has a simple retrofit relay-based AC power control system that allows remote one-touch on/off control of your entire installed audio system including powered speakers.

Daisy Chaining Sequencing Panels

Daisy Chaining Sequencing Panels

LynTec sequencing panels can be daisy-chained together to sequence on and off an unlimited number of circuits with the touch of a single button. This video demonstrates basic wiring between panels. Applies to PDS-10, MSLC, and MSP panels.

Wiring a Switch Set

Wiring a Switch Set

Directions for wiring the LynTec SS-2, SS-2PL and SS-2LRP switch sets.